Train driver killed in Bedford crash died from traumatic injuries, inquest told

Shaun Burton, 60, died in a collision between two East Midlands Railway trains on Friday.
Credit: Family photo/British Transport Police
Shaun Burton, 60, died when the East Midlands Railway (EMR) train he was driving hit the back of a stationary train run by the same operator. Credit: Family photo/British Transport Police

A train driver killed in a 49mph crash in Bedfordshire is believed to have died from “traumatic injuries to the brainstem and chest”, an inquest heard.

Shaun Burton, 60, died when the East Midlands Railway (EMR) train he was driving hit the back of a stationary train run by the same operator.

The Rail Accident Investigation Branch (RAIB) published an interim report on 24 June, which stated Mr Burton’s train had proceeded past a red signal near the scene of the crash in Elstow near Bedford on 19 June.

An inquest into the circumstances surrounding Mr Burton’s death opened at Bedfordshire and Luton Coroner's Court, in Ampthill, on Tuesday.

The coroner’s officer, Natalie Shirran, said: “On 19 June 2026, at approximately [5.14pm], a collision occurred south of Bedford Rail station between train 1H46 and the rear of stationary train 1B67.

“Train 1B67 had stopped due to a fault and the driver was contacting the signaller and maintenance staff.

“The signalling system had placed following trains at red signals. Train 1H46 departed Bedford at [5.10pm] and subsequently passed a red signal.”

Some 162 people were injured, 102 of whom needed hospital treatment.

The train’s speed had reduced to 49mph when the impact happened. Credit: Chris Radburn/PA

As of when the RAIB was published around three weeks ago, 53 remained in hospital, including eight in a critical condition. They have all since been discharged from critical care.

Images from a forward-facing CCTV camera on Mr Burton’s train show a signal near the scene of the crash “was displaying a red aspect as the train approached and then passed it”, the RAIB said.

Train data from the wreckage shows the brakes were applied while the train was travelling at 77mph, about 200 yards before the crash, the court heard.

Its speed had reduced to 49mph when the impact happened.

Mr Burton’s train was fitted with automatic warning system (AWS) equipment triggered by magnets on tracks.

This sounds a bell or chime in the driver’s cab when it is approaching a green signal, and a horn when coming up to a non-green signal.

In the case of the latter, drivers are required to acknowledge the warning by pressing a button.

Cranes were used to lift the train carriages clear of the tracks. Credit: ITV News Anglia

After this happens, a visual indicator appears in the driver’s cab as a reminder. The train’s emergency brake is applied if the warning is not responded to quickly enough.

The RAIB statement said the stationary train involved in the collision had come to a stop “unexpectedly” after a fault with its AWS equipment caused its brakes to apply.

This resulted in the signal behind it automatically changing to red, investigators said.

Approaching trains should stop at red signals.

A post-mortem examination was carried out by consultant pathologist Dr Virginia Fitzpatrick-Swallow on behalf of the coroner’s service.

Mr Burton’s cause of death has been recorded as: “Traumatic injuries to the brainstem and chest, pending further investigations.”

His family had been informed that the inquest was set to open, but did not attend court.

Coroner Emma Whitting said: “I would like to take this opportunity to pass on my condolences to Mr Burton’s family, friends and colleagues for their loss.”

The inquest has been adjourned until the conclusion of the RAIB and British Transport Police investigations.


Want a quick and expert briefing on the biggest news stories? Listen to our latest podcasts to find out What You Need To Know